Trash Can Outfeed
To save space, my trash can doubles as a work support. I made a dolly with locking casters to fit the can’s bottom, so I can roll the unit to wherever it’s needed. The work support is adjustable in …
Source
Tricks of the Trade
New Road for Old Drivers
I use lots of Phillips-head sheetrock screws, which are made of hardened steel. They’re tough on bits. A worn-out bit can’t be re-sharpened, so I reshape it to fit a slotted screw using a small diameter sanding drum. I place …
Source
New Road for Old Drivers Read More »
Homemade Hose Adapter
Hoses and dustports come in so many different diameters that you can go crazy trying to match them up. Sometimes, you can find a hose or adapter that will fit inside a dustport, but its smaller diameter reduces airflow. To …
Source
Homemade Hose Adapter Read More »
Foam-Tubing Seal
After hooking up my new dust collector to my contractor’s saw, I found that it just didn’t pull as much air as I’d like, even after sealing up the most obvious leaks. After further inspection, I found the problem: major …
Source
Random-orbit Buffer
To prevent rust and reduce feed friction, I apply paste wax regularly to my metal tool tables and other surfaces. It does a great job – but what a chore to buff the wax by hand! To make the job …
Source
Random-orbit Buffer Read More »
Crosscut Sled Cam Clamp
CROSSCUT SLED CAM CLAMP I use a sled for cross cutting 3/4-in. melamine and plywood panels up to 24 inches wide. These panels can be hard to hold in position while making a cut, so I installed a cam lever …
Source
Crosscut Sled Cam Clamp Read More »