Back Rabbets
The fastest way to rabbet the back of a cabinet is to do it all at once, after the cabinet is assembled. Unlike rabbeting individual pieces before assembly, I don’t have to worry about where to start or stop a …
Source
Workshop Tips
Precision Planing Jig
Achieving exact thickness is really important when making splines to reinforce box corners. The splines have to fit perfectly in the saw kerfs—a few thousandths of an inch one way or the other can make a big difference. I cut …
Source
Precision Planing Jig Read More »
No More Loose Drawer Knobs
Drawer knobs that work loose and spin around drive me crazy. So instead of drilling a hole through the drawer front and screwing the knobs on from the back, I fasten them to a post that’s securely anchored in the …
Source
No More Loose Drawer Knobs Read More »
Thin Rips on the Band Saw
As a guitar maker, I rip a lot of very narrow wood strips, which can be difficult and dangerous to cut on a table saw. Instead, I cut them on the band saw using a low-profile fence, which allows setting …
Source
Thin Rips on the Band Saw Read More »
Trash Can Outfeed
To save space, my trash can doubles as a work support. I made a dolly with locking casters to fit the can’s bottom, so I can roll the unit to wherever it’s needed. The work support is adjustable in …
Source
New Road for Old Drivers
I use lots of Phillips-head sheetrock screws, which are made of hardened steel. They’re tough on bits. A worn-out bit can’t be re-sharpened, so I reshape it to fit a slotted screw using a small diameter sanding drum. I place …
Source
New Road for Old Drivers Read More »