Woodworking Posts

And I should be done.  However I have been distracted several times so I am behind schedule. The top is completed with the square catch hole [made the wooden part of the catch] and all holdfast holes are drilled.  The legs are all joined with dovetail and rectangular tenons on the top and the 2″ […]

While deep into dovetailing a small chest at the Connecticut Valley School of Woodworking this summer, my concentration was suddenly burst by someone at my workbench. “There’s a guy outside,” the student says, “and he’s selling all his woodworking stuff.” I nodded and then returned to my dovetails. I run into people all the time

Well with everyone building a Roubo workbench, I thought I would make one.  I started today and finished the top, solid slab of birch 32″ wide, 96″ long and 6″ thick.  The legs are maple 6 by 6 inches and just under 36″ tall with a dovetail and rectangular tenon on the ends.  I fit

One of the great joys of reading old woodworking magazines is that they includes lots of tidbits that aren’t in old woodworking books – such as the one I found last night about the “Shangie.” What’s a Shangie? It’s a shopmade device that converts a typical 26” handsaw into a two-man saw that is designed

When it comes to most things in woodworking, I’m an easy-going guy. But not with tool chests. I’m OK if you make your sliding dovetails with a router. I’m just Jim Dandy if you sand, scrape or plane your finished surfaces – we all end up at the same place (with differing amounts of debris

When it comes to most things in woodworking, I’m an easy-going guy. But not with tool chests. I’m OK if you make your sliding dovetails with a router. I’m just Jim Dandy if you sand, scrape or plane your finished surfaces – we all end up at the same place (with differing amounts of debris